Harken 46.2ST Winche - Manual (Page 10)

10 Radial Winch 46.2 ST Installation and Maintenance Manual
Carry out Procedure1 as shown in the paragraph on winch installation and then do the following:
6. Completely unscrew the three screws n° 28
and remove the stripper arm support n°22
8. Unscrew the 5 hex screws n°17
( 20Nm/177 in-lb)
10. Remove the gear n°15
7. Slide out the central shaft n°20
9. Remove the assy housing n°16
Important: washer n°13 may remain inside the
drum support!
11. Remove the washer n°13