Harken 46.2ST Winche User Manual
Page 5
Advertising
5
Radial Winch
46.2 ST
Installation and Maintenance Manual
The winch can be installed following one of the two procedures below (
Procedure1 or Procedure2):
Procedure1
To install the winch you must remove the drum and use Socket Head (SH) bolts.
Tools needed
One medium flat-bladed screwdriver
To identify the various parts, refer to the exploded view at the end of this Manual.
Torque to apply when assembling
1. Unscrew the central screw ( 2Nm/18 in-lb)
2. Slide off the assy socket n°30 and the cover
n°29
3. Unscrew the three screws n°28
( 4Nm/35 in-lb)
4. Remove the self-tailing arm n°27 by rotating
and lifting it.
Advertising
This manual is related to the following products: