Harken 60.3ST Winche - Manual (Page 13)

13 Radial Winch 60.3 ST Installation and Maintenance Manual
Assembly
Make sure that the holes and drainage channels in the base of the winch are not obstructed.
Assemble the winch in the reverse order of the sequence in the section on disassembly.
To tighten bolts, use the torque indicated in the disassembly procedure.
Theicon ontheStripperArmHousing
indicatestheStripperArmfinalposition.
ChangetheStripperArmHousingangle
tomodifytheStripperArmfinalposition.
Whenpositioningthestripperarm,align
thepeelerwithit.
Ifthejawshavebeendisassembled,
insertpeelerbetweenthetwojaws,taking
carethatthelettersTOPonthepeeler
arefacingupwards.
OIL
IncaseofdoubtconcerningtheassemblyprocedurecontactHarken®TechService:
[email protected]
To assemble the clutch pin
Mountthespringwiththepinpointing
upwardssothatitiswoundinananti-
clockwisedirectionstartingfromthepin.
To assemble the pawls
Correctlypositionthespringinitshousing
asshownatleft.Holdthespringclosed
andslidethepawlintoitshousing.Once
inposition,checkthatthepawlscanbe
easilyopenedandclosedwithafinger.