DeLorme 6 - Manual (Page 386)

XMap User Guide
378
Use the following steps to send route points to your device.
1. Connect your device to your computer.
2. If you are using a third-party GPS receiver, you may have to use specific
settings. For example, if you are using a GARMIN GPS receiver, set your
GARMIN receiver interface to GRMN/GRMN. For more information, see your
owner manual.
3. Click the Exchange button on the toolbar.
4. Click Use Other Device to open the Exchange Wizard.
5. Under Select Device, select GPS or point to Athletic Device and then select
your device.
6. Select Send to Device.
7. Select Route Points from the Object drop-down list.
8. Click Next.
9. From the Route drop-down list, select the route file that contains the route
points you want to send to your device.
10. To avoid overwriting existing waypoints on your device, type a starting point
for the new points and select the Prefix a Number to the Waypoint Name
check box. Not all devices support starting points. For more information, see
your device manual.
11. Click Send to Device.
12. Repeat the steps for every route file you want to send to your device.
13. Click Finish.
To Send Route Directions
Use the following steps to send route directions to your GPS device.
1. Connect your device to your computer.
2. If you are using a third-party GPS receiverthird-party GPS receiver, you may
have to use specific settings. For example, if you are using a GARMIN GPS
receiver, set your GARMIN receiver interface to GRMN/GRMN. For more
information, see your device manual.
3. Click the Exchange button on the toolbar.
4. Under Select Device, select GPS or point to Athletic Device and then select
your device.
5. Select Send to Device.
6. Select Route Directions from the Object drop-down list.
7. Click Next.
8. From the Route drop-down list, select the route file that contains the route
directions you want to send to your device.
9. Designate a route name and/or a route number for the file on the device
(device dependent).
10. To avoid overwriting existing waypoints on your device, type a starting point
for the new points and select the Prefix a Number to the Waypoint Name
check box. Not all devices support starting points. For more information, see
your device manual.
11. Click Send to Device.