HP Velotechnik Spirit - Manual (Page 41)

Maintenance and car
e
HP
Velotechnik
39
Changing single tubes
Open the chain as described above and remo-
ve it entirely from the tube you want to chan-
ge.
Use a side cutter or sharp knife to cut the zip
tie that holds the tube in the belt. Remove the
old tube from the belt loop.
Put the new tube through the belt loop. Put a
zip tie through the ring in the belt and around
the tube so that the lock of the zip tie lies hid-
den in the belt. Move the chain tube so that
there are at least 5 cm to both the biggest re-
ar sprocket and the chain ring cover at the
front.Tighten the zip tie firmly and cut off the
spare end.
Thread the chain again through the tube.Take
care not to twist the chain. Close the chain
again as described above.