Pt3000_p3, Assembly instruction, Pt3000 – ikan PT3000 User Manual
Page 4: 15” teleprompter
3903 Stoney Brook Dr. Houston TX 77063 | +1.713.272.8822 | www.ikancorp.com | [email protected] | © 2009 ikan Corporation. All right reserved.
ASSEMBLY INSTRUCTION
5
6
Attach Long L-Bracket (Part J) to the assembled parts. Make sure to arrange the long section of Part J as shown in the
illustration, otherwise there will not be adequate room to place the monitor. You will use 4 x Long Phillips head screws
(Part G) and 2 x T-plates (Part C) to attach it. Then, you will use 4 x Long Phillips head screws (Part G) and 2 x T-plates
(Part C) to attach the 10” T-slot (Part O). Make sure to evenly tighten all screws in the assembly.
PT3000
15” TELEPROMPTER
Part-O
Part-G
Part-G
Part-C
Part-J
ikancorp.com
ikancorp.com
Slide the Monitor with mounting bracket onto the 10” T-slot (Part O), aligning the T-slot Nuts with the T-slots of Part O.
Refer to the diagram below.
ikancorp.com
Side View
Part-O
VGA Cable
Part-M
Part-P
Note: The VGA cable will not connect to the monitor if the monitor is slid
all the way flush to Part-M. You must connect the cable before tightening
down the monitor to insure a proper fit for the connections.
3 of 10