Pt3000_p4, Assembly instruction, Pt3000 – ikan PT3000 User Manual
Page 5
Install 4 x T-plates (Part C) and 8 x Long Phillips Head screws (Part G) onto the Metal frame with Prompter Glass (Part L).
Then, slide the Prompter Glass assembly onto the completed Teleprompter frame. Refer to the diagram below.
Attach your camera to the Metal Bracket on the 20” T-slot. To do so, first loosen each screw on the metal bracket and slide
it off the T-slot. Then, use either the ¼-20 or the 3/8 screw to attach your camera to the metal bracket (Some cameras may
require a washer or other spacer in order to fit snugly).
3903 Stoney Brook Dr. Houston TX 77063 | +1.713.272.8822 | www.ikancorp.com | [email protected] | © 2009 ikan Corporation. All right reserved.
ASSEMBLY INSTRUCTION
7
8
PT3000
15” TELEPROMPTER
ikancorp.com
Washer (Not included)
** Some cameras may require
an extra spacer, such as a
washer, in order to fit snugly.
Part-E or Part-F
(depends on your camera)
ikancorp.com
> Install 4 x Part-C on Part-L and
secure with 8 x Part-G (Place the
Part-C on the inner sides)
Part-Q
Part-C
Part-G
Part-L
> Loosen the screws and slide out the Metal Bracket
through the channels
4 of 10