Insinger QuadJet Aqua-Scrubber User Manual
Page 14
Operation & Cleaning Instructions
Aqua-Scrubber
Follow these operation procedures and general
cleaning procedures to ensure your Insinger ware-
washer will give you years to trouble free service.
Operation Instructions
Close the tank drain valve
All water lines must be open. All electrical
circuits
must be on.
Fill the tank(s) by opening the faucet. Each tank
has a “Tank Fill” indication on the back wall. Fill to
this level. The tank should be filled with HOT water.
On the control panel, move the power toggle switch
to the “ON” position. The power light will illuminate.
PART 2 INSTALLATION INSTRUCTIONS
Low Temp Indicator
High Temp Indicator
Power On Indicator
Power On/Off Switch
Pump Start/Stop Switch
Temperature Selector Switch
The Aqua Scrubber has two heat levels, high and
low, controlled by the TEMPERATURE SELECTOR
switch. Move the TEMPERATURE SELECTOR
switch to the desired temperature. The appropriate
indicator light will illuminate indicating that the tank
is heating.
•
Low Temperature is factory set to
approximately 110ºF
•
High Temperature is factory set to
approximately 140ºF
WARNING:
Scalding occurs at 113
ºF. Do not remove
ware from the Aqua-Scrubber with bare
hands. Use a tool to aid in ware removal.
!