InSinkErator LC-50 - Manual (Page 3)

3
Introduction
In This Package
REQUIRED TOOLS/MATERIALS
The following items are needed to install the disposer:
• Screwdriver
• Pipe wrench
• Hammer
The following items may be needed to install the disposer:
• Plumbing putty
• On/Off electrical switch (1/2 HP, 20A DP)
• Hacksaw
• Drain auger or rod
• Connector kit (Part #8301)
• Solenoid valve (Part #14495)
• Siphon breaker (Part #11477)
• Flow-control valve (Part #13763A)
Stopper
Sink Flange Rubber Gasket
Fiber Gasket
Metal Flange
Backup Ring
Mounting Ring
Screws
Screw
Snap Ring
Discharge Tube
Lower Mounting Ring
Mounting Assembly Disposer Discharge Tube Assembly
Dishwasher Inlet
Tailpipe Mount
Wrenchette
The model LC-50 food waste disposer is designed
specifically for light foodservice use in applications
such as:
• Grocery/convenience stores
• Office/church kitchens
• Fast food restaurants
• Bed and breakfast inns
Important – These installation instructions are for the
benefit of the installing contractor. InSinkErator and/or
InSinkErator Factory Authorized Service Centers do not
make original installations. For technical information not
covered in these instructions, contact the supplier, an
InSinkErator Field Sales Representative, or InSinkErator
Foodservice Sales and Service at 1-800-845-8345.
CLEAN THE DRAIN LINE
With a drain line auger, clear away all hardened waste
material in the horizontal drain pipe running from the
drain trap to the main waste line.