DeLonghi PAC 400 - Manual (Page 10)

10
For technical reasons, the temperature is not expressed in degrees but by a line increasing in thickness.
We therefore recommend that when starting up the appliance, the thermostat be turned to maximum
(Pos.“Coolest”). When the desired temperature has been reached move the thermostat slider slowly
away from the maximum cold position until the appliance is switched off by operation of the thermostat.
In this way the appliance has been programmed with the exact temperature degree required, which is
then maintained automatically by the thermostat
ON/OFF button
ON/OFF pilot light
“Alarm” pilot light
Timer ON/OFF
pilot light
Selecting fan
speed button Timer ON/OFF
button
Thermostat
SETTING THE TIMER
The programmer/timer, like all clocks, must be set
to the exact time. If for example it is 4.00 p.m.,
turn the dial in a clockwise direction (following the
direction of the arrow) until the number 4 is lined
up with the arrow pointer (the arrows indicates
4:00 p.m. approximately).
Note :Never turn the dial in an counter-clockwise
direction!
The timer is in effect, an electric clock and works
only if the plug is connected to the power supply.
Whenever the plug is disconnected or there is a
power failure, the programmer stops (the clock is
then “slow”) and must be re-set.
The unit can be used in either programmed or
non-programmed mode.
PROGRAMMED MODE
1) Release B timer button
2) Set the operating times by pushing out the
notches on the dial corresponding to the peri-
od required (each notch represents 15 mins.).
3) Check that the timer indicates the correct time
(see instructions on setting).
4) Select the desired function as shown in the
chart overleaf.
The unit will now switch on and off each day
at the selected times and the Timer ON/OFF
pilot light will be on.
Note: To override the programmed operating
times, simply press the ON/OFF key.
NON-PROGRAMMED MODE
1) B TIMER button must be pressed
2) Select the desired function as shown in the
chart on the following page.
11 9
4
10
arrow pointer
11 10 9
4
Funzionamento
ex. from 9 to 11 a.m.
A
B C
C o n t r o l p a n e l
Operating time
PAC400 24-04-2003 16:29 Pagina 10