DeLonghi PAC 400 - Manual (Page 8)

8
INTERNAL UNIT
Install the internal unit inside the room to be air-
conditioned. This is usually done near a window or
at least close to an outside wall.
The internal unit must be placed “on the level”,
with the help of the castor-stops provided. No
obstacles should block this unit’s in-take (suction
grille, rear part of the unit) or out-take (outlet grille,
front part of the unit) areas.
EXTERNAL UNIT
The external unit may be placed on a terrace or
balcony, in which case the brackets need not to be
used.
The external unit can be attached to a wall with the
accessories included as follows:
1) Attach the bracket to the
wall while taking care to
place it as indicated in the
drawing. Use the included
template located on the
plastic cover in order to drill
the holes.
2) To fix the support blocks
to the external unit
remove the two screws
already inserted in the
holes. Then screw the
support blocks with the
included M4mm screws
while taking care to place
them so that the hole for
the screws is on the upper
side.
3) Attach the external unit to
the bracket by means of
the M6mm screws.
For temporary installation it is possible to hang the
external unit as illustrated in the drawing. In this
case, use the included straps by attaching them to
the eye hooks. Before inserting the eye hooks
remove the rubber plugs.
The external unit may be installed above or at the
same height as the internal unit, on the condition
that the difference is no more than 5” (1.5 m.)
The suction and air-delivery portions of external unit
must not be blocked by obstacles of any nature.
The distance between the back of the appliance
and the wall must be six 2
1/2 ” (6) cm.
The condensation which forms while this appli-
ance is running (summer time operations) is dis-
posed of by evaporation from the external unit.
If the humidity is too high (in special cases), you
must use the drainage coupling provided to get rid
of condensation. This device must be mounted on
the bottom of the external unit (see drawing) after
the rubber plug has been removed.
We strongly recommend that you protect the
external unit from rain, snow, direct sunlight and
water dripping from the roof.
Castor
Drainage
Coupling
Gasket
1
2
S e t t i n g u p
PAC400 24-04-2003 16:29 Pagina 8