DeLonghi PAC 400 User Manual
Page 9
9
ELECTRICAL CONNECTIONS
Check that the power supply voltage is the same
as the one indicated in the rating label.
Important: If you need to use an extension
cord, please be sure to use a heavy
duty extension cord (minimum 14
gauge).
Before connecting the Pinguino to power supply,
make sure that all switches on the front control
panel are in the OFF position.
Connect power cord found in storage compart-
ment at rear of Pinguino.
Replacement of the power cord must be car-
ried out by qualified personnel.
A LAST LOOK AT THE ROOM
There are several precautions you should keep in
mind so as to get the best use out of your air con-
ditioner:
•
Close the doors and windows in the room to be
air-conditioned (except for installations, in
which one window must be left partially open).
•
In order to insure low-cost operations, protect
the room from direct sunlight by drawing the
curtains and/or by partially lowering or closing
the shutters or blinds
•
Do not place objects on top the air-conditioner.
•
Do not block the suction and air delivery areas.
•
Make certain there are no heating sources in
the room.
Note: Before connecting this appliance to the elec-
trical circuit, make certain that all the buttons
on the control panel are switched off.
IN THIS WAY, YOUR AIR CONDITIONER IS
READY TO WORK, so now let’s familiarize our-
selves with its controls.
Do not use outdoors.
Close the windows
Close the doors
Draw the curtains
Lower (or partially close) the shutters
Do not cover
This appliance is equipped with a safety system which prevents the compressor from turning on
until at least three (3) minutes have elapsed since the appliance was last turned off.
R e c o m m e n d a t i o n s
PAC400 24-04-2003 16:29 Pagina 9