Kemppi FreshAir Pressure Flow Control unit - Manual (Page 11)

EN
5. MAINTENANCE AND CLEANING
FA Pressure Flow Control unit
Every time you finish work, it is recommended to clean the FA Pressure Flow
Control unit, to check individual parts and to replace the damaged ones.
• Cleaning must be carried out in a well ventilated room. Avoid
inhaling the harmful dust settled on individual parts of the unit and
accessories.
• It is forbidden to use cleaning agents containing solvents or abrasives.
Mild soap detergent and warm water is recommended.
• The air hose can be rinsed with clean water.
• Use a damp cloth for cleaning. Each part must be wiped dry after
cleaning.
FA Pressure Conditioner
• Once a week, drain the condensate from the bottom of the unit, using
the drain cock located at the base of the unit. Before completing
this operation, it is recommended to disconnect the unit from the
compressed air supply.
• Replace the filter at least once every three months. After this period,
viruses and bacteria may proliferate in the units filter and if it is used
regularly, the absorption capacity of the activated carbon to eliminate
odour may be exhausted. If the air leaving FA Pressure Conditioner
smells in any way, replace the filter immediately. When replacing the
filter, clean the inner part of the container with a dry cloth.
6. SPARE PARTS
6.1 Assembling FA Pressure Conditioner
Screw the pressure conditioner body onto the stand.
11
© Kemppi Oy / 1309