TTI TCB-881 - Manual (Page 3)

ENGLISH
1. Introduction
1 unit
1 unit
1 unit
1 unit
2 pieces
3 pieces
2 pieces
1 piece
TCB-881 transceiver is designed to have a good performance
in any conditions that the transceiver operates, using rugged
build chassis, PCB’s and components. This transceiver is also
designed for users’ convenience, implementing human ergono-
mics to locate the knobs and buttons in the proper places. The
combination of well designed knobs and buttons as well as user
friendly graphic layouts will lead users to quickly adapt themsel-
ves for the easy operation. The newly applied menu mode will
make professional users more satisfactory with pleasure. The
elegant and luxury blue LED light supporting the face design
will go well with any vehicles.
This instruction manual has been designed to enable you to get
the best use from your CB Transceiver, therefore you are reco-
mmended to take a few minutes to read this instruction manual
before initial use of your CB Transceiver.
Your transceiver is supplied with a full range of accessories to
help you get started and virtually benefit from all the features
straight away.
TCB-881 transceiver
Microphone with cord
Power cable
Radio mounting bracket
Radio mounting thumb screw with rubber washer
Mounting screw with washer (for transceiver bracket)
Mounting screw with washer (for microphone bracket)
Microphone mounting bracket
2. Supplied Accessories
Plan the location of the transceiver and microphone first, which
is most convenient for the operation. The transceiver should
normally be mounted horizontally, but may be mounted
vertically. The bracket supplied can be fitted above or below the
case allowing the TCB-881 to be cradled by the bracket or
suspended from it.
3. Installation
3 TCB-881