KIP 7170K - Manual (Page 24)

Chapter 1 Before Use 1-17
1. 7. 3 Treatment against environmental condition
Take a necessary treatment according to the environmental condition as shown below.
Humidity(%) Possible problem Necessary treatment
Low
40%
70%
High
“Void of image”, “crease of paper” and
other problems occurs when you print
with plain paper and tracing paper.
1. Install the humidifier in the room, and
humidify the room air.
2. Remove the paper from the machine
right after the completion of print, and
keep it in a polyethylene bag.
“Void of image” occurs when you print
with tracing paper.
If you will not make print soon, remove
the tracing paper from the machine and
keep it in a polyethylene bag.
Remove the paper from the machine after
everyday use, and keep it in a
polyethylene bag.
“Void of image” occurs when you print
with plain paper and tracing paper.
If you will not make print soon, remove
the tracing paper from the machine and
keep it in a polyethylene bag.
“Void of image”, “crease of paper” and
other problems occurs when you print
with plain paper and tracing paper.
1. Turn on the Dehumidify Heater*.
(if installed)
2. Remove the paper from the machine
right after the completion of print, and
keep it in a polyethylene bag.
*Dehumidify Heater (DEHUMIDIFY KIT) is optional parts.
NOTE
(1) KIP7170 has an optional part DEHUMIDIFY KIT.
Using it in high humidity environment (75% or higher) is recommended.
Refer to [2.9 Dehumidifying Roll Paper].
(2) “Void of image” and “crease of paper” will occur in case of extremely high or low
humidity.
Normal Print
Normal Print
If the media is humidified;
If the media is humidified;
Crease of paper
Loss of image