Datamax M-Class Mark II M-4206 - Manual (Page 39)

M-4206 33
4.8 Internal Labels
The following section details the printer’s internally generated configuration and test labels.
4.8.1 Database Configuration and Dot Check Labels
The Database Configuration Label provides valuable printer information including the firmware version, memory
allocations, enabled options, and label-counter data.
To print the Database Configuration and Dot Check Labels:
With the printer on, loaded with media (at least 4 inches wide) and ribbon (if printing with thermal transfer media), press
the
FEED
+
CANCEL
buttons simultaneously.
The first label printed will be the Database Configuration Label.
FRI JANUARY 10, 2003 19:29 010
VER: M4206 - 05.03 01/07/03
BOOT 83-2383-05C
CODE 83-2385-05C
FPGA 83-2384-05A
FONT 83-2386-05C
256K FLASH MODULE B
SYSTEM FLASH SIZE_____2 MBYTES
SYSTEM RAM CHECKS____ GOOD
SYSTEM RAM SIZE___ 4096 KBYTES
SYSTEM RAM AVAIL__ 3180 KBYTES
AUTO DETECTION
CUTTER____________NOT DETECTED
PRESENT SENSOR____NOT DETECTED
CURRENT STOP LOC__TEAR
EXPRESS SETUP
MEDIA SENSOR______EDGE
PRINT METHOD______TRANSFER
OPTION CONTROL____AUTO
INPUT VALUES
PAPER_____________ 207
DARKNESS__________ 119
TRAN______________ 157
REFL______________ 0
RIBN______________ 237
TEMP______________ 64
VOLT______________ 218
PRESENT SENSOR____ 0
CONFIGURATION
SERIAL PORT SELECTED
19.2; 8BITS
EDGE
MEDIA TYPE________ TRANSFER
CONT FORM LENGTH__ 0
PRESENT ADJUST____ 128
SOP ADJUST________ 128
TOF LOW___________ 0 0
TOF DELTA_________ 10 10
TOF GAIN__________ 7 5
OOS MAXVOLT_______ 3 2
LABEL ALIGNMENT___ AUTO
ALIGN LENGTH______ 611
STOP LOCATION_____ AUTO
INPUT MODE________ DPL
DPL EMULATION_____ STANDARD
HEAT______________ 10
COUNTER INFORMATION
ABSOLUTE VALUES 1- 7-2003
LENGTH____ 773 INCHES
TIME______ 20 HOURS
RESETTABLE VALUES 1- 7-2003
LENGTH____ 576 INCHES
TIME______ 10 HOURS
MEMORY CONFIGURATION
INTERNAL MODULE A______ 128
SCALABLE FONTS_________ 64
LABEL SIZE 0426:11255 IN