Dolby Laboratories CP65 - Manual (Page 50)

B-Chain Alignment Procedures
Action Indication Step
No.
5-22
0
1
2
3
4 5 6
7
8
9
10
select local/remote mute
local active
auto
subwoofer
off
CAT. NO. 441
1
2
3
d. Subwoofer Alignment (Cat. No. 441)
10 Dolby Stereo
Digital
B-Chain Alignment Procedures
Notes
5-23
d. Subwoofer Alignment (Cat. No. 441)
CP65 processors may be supplied in a number of different configurations.
If the CP65 being installed does not contain a Cat. No. 441, skip this procedure and the
next procedure and go directly to part, Adjustment of Surround Delay, on page 5-43.
The Subwoofer auto/off switch on the Cat. No. 441 card enables the subwoofer in
formats other than Non-sync (format 60) , Mono (format 01) and magentic no NR (format
22). The switch must be in the auto (up) position at any time the subwoofer system is to
function.
Confirm that the microphone is in the position defined on page 5-7.
All connections established in the room equalization procedure apply to the following
steps.
The main front panel FADER should be active and set to 7. If necessary, press the select
local/remote switch.
Place the Le toggle switch on the Cat. No. 85C card in the ON (up or down) position and
set the CP65 to format 10 Dolby Stereo Digital.