Canon XLH1 - Manual (Page 79)

79
Recording
E
Master Pedestal [PED] (only in CAMERA mode)
Adjust the master pedestal level in the range -9 to +9.
Setup Level [SET] (only in CAMERA mode)
Adjust the setup level in the range -9 to +9.
• Depending on the value set for the master pedestal [PED], the setup level may not be able to take a
negative value. In that case, adjusting the setup value within a certain value range will have no effect.
Sharpness [SHP]
Adjust the sharpness level in the range -9 to +9.
Horizontal Detail Frequency [HDF]
You can select from [HIGH], [MIDDLE] or [LOW].
Horizontal/Vertical Detail Balance [DHV]
Adjust the horizontal/vertical detail balance in the range -9 (only horizontal) to +9 (only vertical).
Coring [COR]
Adjust the detail noise level in the range -9 to +9.
Noise Reduction 1 [NR1] (only in CAMERA mode)
You can select from [OFF], [HIGH], [MIDDLE] or [LOW].
• With the [HIGH] setting moving subjects may leave a trailing afterimage.
• When picture noise is already low due to the gain settings, the noise reduction function may not be
noticeable.
Noise Reduction 2 [NR2] (only in CAMERA mode)
Results in an effect similar to applying the skin detail function over the whole picture. You can select from
[OFF], [HIGH], [MIDDLE] or [LOW].
• Unlike with the NR1 setting, a trailing afterimage will not appear.
Color Matrix [CMX] (only in CAMERA mode)
You can select from [NORMAL], [CINE1] or [CINE2].
Color Gain [CGN]
Adjust the color saturation level in the range -9 to +9.