Leprecon W-DMX G4 MK I - Manual (Page 11)

4 BlackBox and WhiteBox F-1
20 W-DMX G4(S) User Manual, edition 2 2013-10
4.6 Operation as a transmitter
 The unit is in Transmit Mode (TX) working as a transmitter.
4.6.1 Prerequisites for successful linking with receivers
Hint
The figures are maximum figures and depend on output
level and environment. Local settings may be required.
1. For advanced settings and projects, contact your
distributor.
 Max. distance to transmitter (air):
– 200 m (Micro units)
– 500 m (BlackBox, WhiteBox and ProBox in ETSI mode)
– 750 m (BlackBox, WhiteBox and ProBox in FCC mode)
 Distance to transmitter (glass): up to 500 m
 Distance to transmitter (wall, except concrete): up to 350 m
 Distance to transmitter (concrete): up to 150 m
4 BlackBox and WhiteBox F-1
2013-10 W-DMX G4(S) User Manual, edition 2 21
 Position above crowds: min. 1 m
 Position above trees: min. 1 m
4.6.2 Linking receivers
Hints
You can link receivers at any time, also during operation.
During the linking procedure the DMX transmission is
interrupted.
Linking a transmitter to a receiver means that any
DMX data put into the transmitter is output at the receiver.
1. Power on the receivers you want to link.
2. Ensure that the receiver is not connected to any other transmitter, i.e., the
LINK LED on the receiver is off:
If required, see chapter "4.7.2 Unlinking from transmitters", page 23.
3. Press the red function button of the transmitter momentarily (1 second).

The transmitter scans for all unlinked receivers for a period of about
5 seconds. The LINK LED flashes rapidly:
 If the connection is successful, the LINK LED on the receiver goes on. If
DMX input is available, the DATA LED goes on as well:
 If the connection fails, check the position of the receiver, see chapter "4.6.1
Prerequisites for successful linking", page 20.
 The signal bar on the receiver indicates the received signal strength.
2014-03 W-DMX G4(S) User Manual, edition 3 2014-03 W-DMX G4(S) User Manual, edition 3