Louroe Electronics TLMC-W - Manual (Page 4)

OPERATIONS AND TEST OF TLMC-W
1) FOR NORMAL OPERATION (MANUAL RESET)
A. The Louroe Base Station can be triggered either by pressing the call button
or by generating a loud sound or shouting (when used with Alarming Base
Stations DG-12II/25III Series).
B. Move slide switch “S2” of TLMC-W PC Board to position marked “N”.
C. Once an alarm is initiated, the operator at the Louroe base station can respond to
the TLMC-W that initiated the call. The call acknowledge LED on the front panel
will illuminate indicating that the call was received and acknowledged by the
operator.
2) FOR TIMED OPERATION (AUTOMATIC RESET)
A. Move slide switch “S2” to position marked “T”.
B. Select the desired time for microphone to be activated --- 30 seconds or 60 seconds.
For 30 seconds of activation, move switch #1 to ON position.
For 60 seconds of activation, move switch #2 to ON position.
Only one switch can be in the ON position.
C. Press the call button to initiate an alarm. When the person at the base
station responds, the “call acknowledge “LED” will illuminate, activating
the TLMC-W’s microphone for bi-directional communications with the
base station.
D. After time duration (either 30 seconds or 60 seconds), microphone in the TLMC-W
will shut off. To continue communications with the base station,
press call button again.
Page 4 of 8
LOUROE ELECTRONICS 6 9 5 5 VA L J E A N AVENUE, VAN NUYS, CA 91406 TEL (818) 994-6498 FAX 994-6458
website: www.louroe.com e-mail: [email protected]
(818) ®
INSTALLATION AND OPERATING INSTRUCTIONS
tlmc_w_inst_3/15