LSC Lighting GenVI - Manual (Page 5)

GenVI Dimmer Product Description
Operator Manual V1.0
Page 1
1 Product Description
1.1 ABOUT THIS MANUAL
This manual describes the installation, configuration and operation of the GenVI range of
advanced dimmers manufactured by LSC Lighting Systems.
1.1.1 Conventions Used in this Manual
There are four different colour themes that you can select on the GenVI touch screen. The
screen images in this manual use the default “Gothic” colour theme.
Throughout this manual, certain conventions have been used to make the meaning clearer.
 A word in Bold text represents a button on the touch screen.
 Emphasis is indicated by underlining.
 Notes or Hints are displayed in italic font
1.2 OVERVIEW
The GenVI dimmers can be controlled by any DMX512 or RDM lighting controller. Dimmer
configuration, patching and local control is achieved via a backlit colour touch screen on the
front panel. A lock code can be used to prevent unauthorised tampering. Most control
functions, configuration options and front panel operations can also be remotely controlled
using the RDM (Remote Device Management) protocol.
1.2.1 Features
 DMX512 (1990), DMX512-A (E1-11) and RDM (E1-20) compliant control.
 If DMX is lost, the GenVI can either hold the last values or fade to a “DMX Loss
memory” after a programmable delay.
 RCBO (Residual Current Breaker with Overcurrent) per channel. This is a combined
overload circuit breaker with earth leakage (RCD/GFI) protection and Neutral
Disconnect function for each circuit.
 Individual dimmer channel settings for:
o DMX address patching.
o Minimum and maximum output levels.
o Choice of two fade curves (linear or s) or switched power output. Switched (LSC
Trupower) output provides direct power by utilising relays guaranteeing there
are absolutely no electronics in the circuit to interfere with connected loads.
 LSC’s proprietary Current Control Technology © (CCT) protects all RCBO’s from
nuisance tripping due to cold lamp inrush currents.
 13amp or 10amp per channel models.
 Choice of output connectors.
 Settable constant fan speed or fully automatic.
 16 bit internal architecture which gives smooth fades. Essential when dimming LEDs.
 16 bit DMX control selectable for super smooth fades.
 Pulse transformers fired dimmers will dim most types of loads. See section 7.
 100% duty cycle operation across all channels simultaneously.
 CE and C tick approved.
1.2.2 GenVI Control Philosophy
Each GenVI dimmer channel can be individually configured to be controlled by either:
1. DMX Only. When configured for “DMX Only”, a dimmer channel is controlled from a
DMX lighting controller. If DMX fails, the channels can either hold their last state or
after a programmable delay time, fade to a “DMX Loss Memory” previously stored in
the GenVI.
2. Auto Power. When “Auto Power” is enabled, channels configured for “Auto Power”
will be automatically switched ON at full level whenever any valid DMX signal is
detected. These channels will remain on for a programmable “hold time” when DMX is
no longer detected. A channels “curve” must be set to “NonDim” before “Auto Power”
can be selected. See section 3.8.4
Dimmer channels can also be controlled from the touch screen by selecting Riggers Control.