LSC Lighting ePRO - Manual (Page 17)

ePRO Dimmer
Operator Manual V3.0
14
8 COMPLIANCE STATEMENTS
8.1 C Tick Compliance
The ePRO Dimmer from LSC Lighting Systems (Aust) Pty. Ltd. has been designed and conforms to the
following standards:
EN55015 (Limits and methods of measurement of radio disturbance of electrical lighting and similar
equipment)
.
IEC60439 (Low-voltage switchgear and control gear assemblies)
IEC60950 (Specification for safety of information technology equipment including electrical business
equipment).
8.2 CE Compliance
All LSC products with CE Compliance automatically comply with C-Tick requirements as per Section 182 of
the Radio communications Act 1992. LSC Company Registration number is N921.
8.3 Disclaimer
LSC Lighting Systems (Aust) Pty. Ltd. has a corporate policy of continuous improvement, covering areas
such as product design and documentation. In light of this policy, some detail contained in this manual may
not match the exact operation of your product.
In any event, LSC Lighting Systems (Aust) Pty. Ltd. can not be held liable for any direct, indirect, special,
incidental, or consequential damages or loss whatsoever (including, without limitation, damages for loss of
profits, business interruption, or other pecuniary loss) arising out the use or the inability to use this product
for its intended purpose as expressed by the manufacturer and in conjunction with this operating manual.
Servicing of this product is recommended to be carried out by LSC Lighting Systems (Aust) Pty. Ltd. or its
authorised service agents. No liability will be accepted whatsoever for any loss or damage caused by
service, maintenance or repair by unauthorised personnel. In addition servicing by unauthorised personnel
may void your warranty.
8.4 Product of Australia
All LSC Lighting Systems products are proudly designed, manufactured and distributed from Australia and
meet the highest certification of “Product of Australia” in the Australian Made Campaign.