Maytag MMC5080AAB Installation - Manual (Page 4)

• Position remaining piece of Template 2 under the cabinet and align the hole center lines with arrows on Template 1 so
that the distance from right hole center to left hole center measures the distance indicated on the templates. (You may
have to cut excess paper from middle of the template to make it lay flat.)
• Position Template 2. (The cut line along the front edge of template must be placed against the back of the front rail.)
DRILLING THE MOUNTING HOLES
While drilling, it is recommended that safety glasses be worn to prevent possible eye damage from cabinet shavings.
1.
Use a center punch or nail to make an indentation for centering the drill bit.
2.
Drill through Template 2 at the four black drilling holes indicated on the template. (Drill should be held straight to ensure proper
alignment of bolts.)
3.
After drilling the four holes, remove the template and clean the drill holes.
SELECTING YOUR MOUNTING BOLTS
1.
You should have three sets of bolts of varying lengths in the installation package. select one bolt of each size.
2.
Hold each bolt against the cabinet front rail. pick the bolt that extends beyond top of the bottom shelf by. 48 cm (3/6") to 2.54 cm (1").
this will be the bolt length needed for your cabinets.
NOTE: It is important to pick the correct bolt length needed for your cabinets. If the bolt is too short it won't reach the oven. If the bolt is
too long, it will not permit oven to be drawn up to the cabinet snugly.
3.
From inside the cabinet, insert the bolts through the mounting straps and then into the drilled holes.
MOUNTING THE OVEN
To aid installation, we suggest that you use some solid support such as books to hold the oven while you are securing it with the mounting
bolts.
Make sure that whatever you use is stacked or cut as close as possible to the height needed for the oven to reach the cabinet bottom.
1.
Place the oven on the support and move into position. Lift oven, aligning the mounting holes on the oven with the bolts. Do not grip
the door handle to help lift the oven.
2.
Insert bolts into mounting holes on the oven. Tighten the bolts to secure oven to the bottom of the cabinet.(Alternate between bolts so
that oven is drawn up evenly.)
3.
Once oven is securely in place, plug power cord into three prong (grounded) wall receptacle.
2.54cm~0.5cm
(1"~3/16")
TOP OF BOTTOM SHELF
Printed in Malaysia