MBM Corporation MBM 25 - Manual (Page 5)

2. Operating instructions
(1) Checks before setting
Caution
Please do not install a machine in the unstable place to which it is
shaky or leans. There is a danger of receiving an injury.
When you move, have a base. There is a danger of receiving an
injury.
When you install a machine, please install to a place with no dust,
and the place which is not influenced with a liquid. It becomes the
cause of failure if the installation method is mistaken.
(2) Operating procedure
Caution
Don't put a hand under the hollow drill bit. There is a danger of
receiving an injury.
Turn off the power supply beforehand when attaching or detaching
hollow drill bits. There is a danger of receiving an injury.
Don't touch the blade point of the hollow drill bit. There is a danger
of receiving an injury.
(1) Setting a drill bit
Insert a drill bit into the chuck and tighten with the provided wrench.
(2) Setting the punch depth
After installing a drill bit, adjust the stop nut that limits downward travel so that the drill bit just
enters the brown fiber plug on the table when the drill bit is fully extended.
(3) Setting paper
Open the paper guide and place the paper on the table.
Close the paper guide the paper will be centered on the table automatically.
Push down both sides of the paper clamp to secure the paper.
Clamping pressure should be set according to the type of the paper.
VS-15: Do not try to punch more than 30mm of paper.
VS-25: Do not try to punch more than 50mm of paper.
４