MBM Corporation MBM 25 - Manual (Page 8)

(5) When thermal protector works
Caution
When a machine stopped during use, turn off the power switch, and
pull out a power supply plug from a wall socket after that.
There is a danger of begins to turn again. And there is a danger of
receiving an injury.
When machine use long hours, motor becomes hot. To avoid the damaging of the motor, rotation
of drill automatically stops by activating of thermal protector. When machine become cold, drill
automatically rotates again if machine switch is not turned off. This might be cause of the injure of
operator. So, when thermal protector works, turn off the power switch and pull out the power supply
from the outlet.
4. Product specifications
VS-15 VS-25
Punch depth 30mm 50mm
Diameter of drill bit 4/5/6mm
4/5/5.5/6/6.5mm
(4mm: Optional adapter is required)
Back margin 6 to 35mm
6 to 35mm (normal)
12.5 to 35 (4mm drill bit)
Maximum paper length
376mm
Automatic centering
376mm
Automatic centering
Table size W480 x D260 mm W480 x D260 mm
Dimensions W480 x D340 x H430 mm W480 x D340 x H470 mm
Net weight 13kg 14kg
120V 230V 240V 120V 230V 240V
Power
AC 50/60Hz 90W AC 50/60Hz 180W
Power cord length 2m (Vinyl-covered) 2m (Vinyl-covered)
5 Ordering consumables, etc.
When ordering consumables or parts such as fiber plug, specify the machine model.
Keep this “Operation Manual” at an appointed place with care so that it may be available whenever
required.
If this “Operation Manual” is stained or lost, make contact with the distributor or our salesman or customer
service section to ask for a new operation manual after making sure of its contents.
When transmitting this product to another person, be sure to attach this “Operation Manual” to the product.
７
UCHIDA YOKO CO., LTD.
9-15, Shiomi 2-chome, Koto-ku, Tokyo, Japan
Tel: 81-3-5634-6350
Fax: 81-3-5634-6856
E-mail: [email protected]