MBM Corporation FMM3 - Manual (Page 14)

Maintenance
Page 13
Note: Some play between the Idler Pulley Bearings and the Idler
Pins comply with original specifications and is not a
problem.
Every 12 Months (or as needed depending on use)
Make sure to unplug the machine from the power supply before
conducting any maintenance.
Remove the Table by loosening the left end Stop Collar on the
Stop Bar Assembly and rotating the Table Traverse Stop down
to clear the Pedestal. Pull the Table to the right until the Table
clears the slide beneath the Table. Inspect the slide for build-up
and lubricate with light machine oil. Using the Foot Treadle
raise the Slide and Lubricate the bars underneath the Slide as
shown. Replace the Table in the same manner as it was
removed and check the Table traverse for free travel.
Lubricate the Stop Pin with light machine oil, work the pin up
and down and rotate it a few times for proper lubrication.
Lubricate the pivot points, shown in the diagram, in the lower
back portion of the machine with light machine oil. Lubricate the
Treadle Pivot Assembly at the front of the machine in the same
manner.
Making sure the machine is unplugged and after disconnect-
ing the electrical wiring to the Switch on the shroud, remove the
shroud by lifting straight up to clear the drive mechanism making
sure the Traverse Locks are disengaged. Lubricate the two (2)
Idler Pulleys with a good grade of grease. A grease gun is
required (not included). Rotate the belts by hand to check the
Idler Pulleys for wear
Lubricate
Lubricate
Lubricate
Lubricate
Lubricate
Lubricate
Grease Points
Belt
Belt
Pedestal
Table Assembly
Slide