MBM Corporation 430 EP semi-automatic programmable - Manual (Page 15)

EBA 430 E • EBA 430 EP
-29-
1.
2.
1.
3.
2.
-28-
B
A
The 3 eccentrics are now exposed and should
be turned counter clockwise to position "0"
with the special wrench (A) (found in tool set).
Until the red arrow-like eccentric marking
corresponds to the position "0" (B).
Remove the special wrench and turn on the
main switch until the blade returns to the home
position.
Danger! Do not put main switch on position
"0" whilst blade is moving upwards! The clamp
must always overlap the blade! Risk of injury!
Remove the 2 blade screws (1.). Then put the
blade changing tool (2.) into place and fasten it
to the blade.
The remaining screws should then be removed
(1.). Loosening the grips of the blade changing
tool lightly (2.) will now allow the blade to be
taken downwards out of the machine (3.).
Clamping Blade
OK
OK