MBM Corporation 430 EP semi-automatic programmable User Manual
Page 18
EBA 430 E • EBA 430 EP
-35-
-34-
A
A
D
B
E
F
C
Cut a stack of paper to test. If the last sheet has
not been cut through move the knob for the
adjustment of the blade depth setting (A) to the
right (about ½ - ¾ turn if maximum of stacking
height is going to be cut - the blade is set
lower - do not set it too low, blade will become
dull sooner.
Danger! Blade must always be covered by
the pressing bar (see picture below at the left
).
Maintenance work may only be performed by
trained staff.
Disconnect the mains before starting any
service work or before removing the cover.
Oil the backgauge (A) control weekly i.e.
grease it. (Use non-resinous oil and grease).
Twice a year the remaining 14
grease parts (B) (see picture).
To do this switch please bring the main switch
to position "0" (E) and move the machine on its
left sidfe.
Danger! of tilting!
Remove cover (C) and lower panel (D) (tools
in tool set).
• Remove remaining paper
• Grease the machine
• Check the two joining bolts and
pushing bar for wear
• Mount the machine upright
Clamping
Blade
OK
OK