MBM Corporation 430 EP semi-automatic programmable - Manual (Page 21)

EBA 430 E • EBA 430 EP
-41-
cm
inch
EBA
"Service"
C
B
A
D
-40-
Motor runs but blade does not move
downwards.
• Security brake has been activated!
Inform the service team!
www.EBA.de
➞ ➞ ➞ ➞ ➞ "Service"
[email protected]
Display illumination off
• Machine is plugged in? (A)
• Main switch on position "I"? (B)
• Key turned to the right ?(C)
• Push in the security button! (D)
• Check the fuse of the buildings’
• electrical installation!
EBA 430 E
Cut cannot be made.
• If cover is open:
close it.
• If cover is closed:
open and re-close it. (Security check).
EBA 430 EP
Cut cannot be made.
• Measurement has not been driven to
correctly.
• LED "S" X does not turn off.
Push again the S button.
Security check of the cover (see above)
• Measurement below 9 cm
Hold the S button O until the measure is
achieved.
• Backgauge I does not move, the display
shows " C "
Turn the pressing lever E to the right.
• Backgauge I does not move to position
(pressing lever has been turned to the right).
"
C " is in the display
➞ inform service people.