MBM Corporation 206M - Manual (Page 9)

8
(5) Preparation
Install Table 1 and 2:
Insert Table 1 on the studs indicated by (a) and (b) as shown in
the picture to the right.
Insert Table 2 on the studs indicated by (c) and (d) as shown in
the picture to the right.
Note:
When setting Table 1, be sure to put its stopper plate at the center position.
Caution:
Be sure that both Table 1 and 2 property fit in the positions of the
studs (a), (b), (c) and (d). If they are improperly set, it may
cause an incorrect collation, or the tables may fall out of the machine.
Setting Paper:
Lift the auxiliary table and place the paper.
Raise the paper feed table lever.
Set the paper guide for the appropriate paper size.
Neatly stack the paper on the feed table with its printed side
facing up. (its printed side down in case of fold-out)
Lower the paper feed table lever to set the paper.
Note:
If the paper does not come in contact with the paper feed roller, remove and reinsert.
Curled or wrinkled paper may not feed correctly – be sure to use flat paper stock.
In case of printed paper, use it only after the ink is dry, otherwise the paper feed rubber roller,
paper separator, fold roller, and other parts of the unit may absorb the ink, causing marking.