Measurement Computing WavePort rev.3.0 - Manual (Page 120)

9-4 Maintenance, Service, and Part Replacement 05-26-00 WavePort User’s Manual
Should I Calibrate the WavePort?
No.
WavePort should be calibrated periodically, but only by the factory, or a factory approved service
representative.
It is recommended that WavePort be calibrated yearly; however, calibration periods often vary, depending
on your application.
If you suspect that the unit needs calibrated you should obtain channel readings from a source with a known
value; then, if the readings indicate a need for calibration, contact the factory.
IOtech can be reached by one of the means provided in the following section.
How do I get Replacement Parts or Service?
Aside form external components, WavePort contains no user serviceable parts. If you suspect an internal
problem you should promptly call your service representative. Be aware that you should never remove
WavePort’s cover plate.
The following parts can be replaced by the user:
• Fan Filter: Media, Guards (1 plastic, 1 metal) and Retainer
• AC Main-Line Power Fuse (2 Amp, Type T, 250 V)
• CA-35-2 DB25M-to-DB25M Cable (connects WavePort to Notebook PC)
• CA-1, IEC Power Cable
• Adhesive Foam Seal, ST-5-6 Tape (for WavePort’s upper-lid, padding for Notebook PC)
• Dual-Lock Fastener with Adhesive (Velcro® type strips for holding Notebook PC to
WavePort’s Cover Plate)
• 1026-0601, Installation CD-ROM (Includes WaveBook and DIAdem Software)
• HA-192, Accessories Pouch – for holding cables and other small items
Accessories
The following accessories can be ordered for use with WavePort. Parts preceded by “CA” are cables.
• WBK20A PC-Card (Option for connecting WavePort to Notebook PCMCIA slot).
Includes PC Card and mating DB25 connector cable, see Appendix B for details.)
• CA-198, 5-pin DIN to Vehicle Cigarette Lighter (length: 10 ft., 3.048 m)
• CA-178, DB25 to external clock BNC
• CA-150-1, Single Male BNC to Male BNC, CE Compliant cable
• CA-150-8, Eight Male BNC to Male BNC, CE Compliant cables