MEGAPOWER MVP-886 - Manual (Page 16)

- 12 -
6.2 STAND BY
Plug in the visualizer power cable after computer, projector
and monitor are fine connected. You will find out the visualizer
power indicator light is in half brightness, computer signal is
outputting to the monitor and projector, also the indicator lights of
monitor and projector are still off.
6.3 HOW TO START UP system
Press “POWER” button to start up the visualizer. The monitor
will turn into blue, and then camera signal will be projected out.
This means the visualizer is ready for work.
After all the indicator lights flicker to still, the visualizer power
indicator light is on its normal brightness. This means the system
is ready to carry on further operation.
6.4 HOW TO SHUT DOWN system
Holding on the “POWER” button for 1 second will shut down
the system and turn it in to “STANDY BY” mode.
6.5 HOW TO SELECT LIGHT
Press “LIGHT” button to select upper light and base light or
just turn off the lights.