Mini Tec 520000 MTD Kit - Manual (Page 20)

20
- Front Caster Setting = 2.5 to 3.5 Degrees (2.5 for a lighter steering wheel, 3.5
for a heavier steering wheel)
- Front Camber Setting = -0.5 to -1 Degree (Less for street driving, more for
racing)
Check List: For your safety, please check…
- That every suspension component
is fastened tightly.
- That the steering system is
fastened properly and all nuts and
bolts are secure.
- For a firm brake pedal.
- That the engine is stationary.
- All fluid levels are full.
- Tires are inflated properly.
- All lug nuts are tight
Test Drive:
For your first test drive, go slow and easy to make sure that there are no problems.
Listen to the car as you drive it for odd noises. Drive the car easily for a few miles
and then go over the Check List again. After driving the car for 100 miles, check
front suspension alignment.
Periodically, you will need to check all of your suspension nuts and bolts for
tightness.
After that, have fun!
Disclaimer of Warranty
Neither the seller nor the manufacturer will be liable for any loss, damage or injury directly or indirectly arising
from the use or inability to determine the use of this product.
Before using, the use shall determine the suitability of the products for its intended use, and the user should
assume full responsibility and risk in connection herewith.
For off road use only!
Copyright 2006 Mini Tec, L.L.C. All rights reserved.