Mini Tec 520000 MTD Kit - Manual (Page 8)

8
Step 2: Drill six holes to support the bottom of the frame using a 5/16” drill
bit. Use the six supplied 5/16” bolts with plates to fasten the frame to the car on the
lower side. The plates will go inside of the car to give the floor panel extra support.
After the six bolts are in place and tightened, tighten the two large frame mounting
bolts on top of the frame. See photos.
Your subframe should now be attached to your Mini.
Coil-Over Shock Installation:
Step 1: Replace Mini upper shock mounts with the provided upper strut
mounts.
Step 2: Attach lower side of shock to the upper suspension arm shoulder bolt.
Step 3: Attach top shock to upper strut mount. See Photo. Do the same for both
sides.