Montigo H38DF PRC - Manual (Page 25)

H*38DF PRC Panorama Indoor Gas Fireplace
Page 25 XG0211 - 150204.1
Installation
Section 9: Installing the Accessories
Figure 25a. Place Logs' "A" on Left & Right stands.
Installing the H38PR* Logset
The H38PR* is supplied with eight (8) fibre logs. The two small bottom
logs ("A" ) are mounted on the burner grate by placing them diagonally
onto the supplied Log stands. The long Front / Back logs ("B") are
placed against the grate as shown in Figure 25b. Note: When placing
logs, arrange Logs "B" as not to cover Burner holes.
Next are the Top logs "C" which are placed diagonally, as shown in
Figure 25c. The last logs "D" is then mounted on top of logs "A" as
shown in Figure 25d.
Installing the Ember Material
The ember material is supplied in two packages. Spread the material
evenly around the burner tray, or pile around burner holes for a realistic
effect.
Figure 25c. Log Installation. Place Logs' "C" on-top of Logs "A".
Indentations on-top of Logs' "A"
Figure 25b. Place Logs' "B" as shown, in front of Right-hand "A",
and behind Left-hand "B".
Log A
Log B
Log C
Log A
Log C
Figure 25d. Completed Installation.
Figure 25. Empty firebox showing the Left & Right stands.
Front of Fireplace
Burners
Log Stand
Log Stand
Burner holes (front & back burner),
note hole pattern when placing logs
Air Inlets
If logs are not placed properly, excessive sooting will result.
NOTICE
Do not use ammonia based or abrasive cleaners on the glass, they will permanently
etch the surface. Use an approved gas fireplace glass cleaner such as Kel-Kem or
White off.
NOTICE
Do not operate this fireplace without the glass door or with a broken glass door.
NOTICE
Log D
Log B
Log D