Montigo PVHEX58-300 - Manual (Page 7)

Installation
Page 7
XG0518 - 070714
Step 16: Secure power head onto the rough in box with the supplied
4 screws. Make sure the power head makes good contact with the
gasket on the top and sides of the rough in box.
Step 15: Push the power head onto the vent. Make sure the power
cable for the power head does not get pinched or caught.
Figure 2r.
PVHEX58-300 & PVHEX510-300 Horizontal Power Vent
Figure 2o.
Figure 2p.
Step 14: Plug the power cable from the power vent head into the
control cable.
Step 13: Slip the Vent Support Band over the vent so that it sits flush
against the back of the rough in box. Tighten the band around the
vent so the vent cannot be pushed back through the hole in the rough
in box.
Figure 2q.
Note: Exhaust chute is pointed towards the ground.