Motion Sound AG-110H - Manual (Page 4)

4
and walls can make each room sound different as they reflect the lush 3D sound from the AG-
110H around you and your audience.
Rotor Controls
Slow: This sets a range of effect from just perceptible through a rich moving field of sound.
The slow setting can provide a sense of space and depth. Set this speed first.
Fast: Faster speeds provide a range of choruses from slow rich movement through tremolo
ranges. (The rotor does NOT provide Leslie-like tremolo.) Set this control after the slow
speed.
Accel produces a range of ramp up and ramp down times. This can be a useful effect if planned
as part of a transition in a performance.
LED Foot Switch
Fast/Slow: When the LED in “on”, the rotor will ramp up to the fast speed setting. When this
LED is off, the rotor will ramp down to the slow speed setting.
Stop: The rotor will ramp down from speed to a complete stop. When the LED is off, the rotor
will ramp to the fast/slow speed setting.
Rear Panel Connections
Line Level Input: You may connect a CD player, PA mixer or other signal source to this ¼”
unbalanced input. The pre-amp gain trim does not effect this input. Volume, tone controls and
reverb are operational. Both inputs can be used simultaneously.
XLR Rotary Output 600 ohm microphone provides rotary sound pick-up for PA or recording
applications. Includes tone reverb and rotary diffuser.
XLR Direct Output provides direct output to PA or recording boards. Includes tone and reverb.
¼ “ TRS Foot Switch: Input for foot switch speed control.
The AG-110H MUST be grounded and connected to a correct power source. The inlet is
standard IEC 320, the removable power cord is standard grounded NEMA and the fuse is located
in the power inlet housing.