MovinCool Classic Plus 14 - Manual (Page 14)

14
INSTALLATION (cont.)
LCDI Power Cord Instruction
WARNING
CAUTION
Procedure
<FRONT VIEW>
The LCDI device is a non-serviceable device.
Attempting to open the device may expose the user to the hazards of electric shock, and
could void warranties of this product.
Manufacturer’s liability is limited to the replacement of the device.
1. Read the attention printed on the device for proper use and handling of this device.
2. This device is used for monitoring leakage current.
3. Do not immerse in water.
4. This device must only be plugged into an appropriate wall outlet. Do not use on
extension cords or adapter. Do not remove ground prong.
5. In the event that this device trips, the cause of malfunction should be corrected first
before further use.
6. Using the device beyond recommended voltage poses risk to users.
7. Conductors inside this cord are surrounded by shields, which monitor leakage
current. These shields are not grounded, and they are periodically examined the cord
for any damage. Do not use this product in the event the shields become exposed.
8. Do not push TEST and/or RESET buttons in a short period.
Test device once when AC is installed to assure proper operation.
1. Plug into grounded power receptacle.
2. If light is not on, press RESET button once. Light should turn on.
3. Press TEST button once, light must turn off.
4. Press RESET button once again for use. Light should turn on.
5. If test fails, do not use.
TYPE 1
TYPE 2
TEST Button
RESET Button
TEST Button
RESET Button