Mr. Coffee BVMC-ECMP55 - Manual (Page 6)

IMPORTANT
To prime the pump before the initial brew, run brewing
cycle for 30 seconds following the steps below:
1. Add water to the water reservoir.
2. Turn the ON/OFF Switch ON.
3. Press the Brew/Steam Switch to the BREW “ ”.
position and wait for Brew/Steam Indicator Light to
become solid green”.
4. Place a cup underneath the brew head and turn the
control knob to the BREW “ ” position.
5. After 30 seconds turn the knob to the off position.
(Some water and/or steam may release during process).
HOW TO BREW ESPRESSO
PREPARATION: Gather the following prior to brewing
• Fine espresso ground coffee
• Tap Water (or, preferably your favorite bottled water)
• Teaspoon
• Your favorite cups/”demitasses
1. Make sure the unit is switched OFF and the control
knob is in the OFF position.
2. Fill the reservoir with water, you may either use bottled
water or a jar to fill it up or remove it from the unit and
then fill it up under the tap. If you have removed it
from the unit to fill up with water, please make sure to
place it back tightly in its place. Fill the reservoir with
the desired amount of water ensuring it ranges within
the “MIN” and “MAX” markings on the tank. Never use
warm or hot water to fill the water reservoir.
3. Close the water reservoir lid.
PREPARING THE COFFEE
Choosing the filter:
Place the filter in the brew basket. Select from the two
E9 E10
stored in an airtight container will keep up to 4 weeks
before they begin to lose their flavor.
BEAN GRINDING TIPS
This is a vital step in the espresso making process and takes
practice. The coffee must be of a fine grind.
• The correct grind should look like salt.
• If the grind is too fine, the water will not flow through
the coffee even under pressure. These grinds look
like powder and feel like flour when rubbed between
fingers.
• If the grind is too coarse, the water flows through the
coffee too fast, preventing a full-flavored extraction. Be
sure to use a quality grinder for uniform consistency. Burr
or Conical grinders are recommended for best results.
BEFORE BREWING YOUR FIRST ESPRESSO
Please refer to Page E6 for the Diagram of Parts.
1. Make sure the unit is switched OFF, the control knob
is in the OFF position and it is unplugged from the
electrical outlet.
2. First remove and then wash the water reservoir, lid,
brew basket and filters in a mixture of mild detergent
and water. Rinse each thoroughly and place them back
into the unit. Refer to the instructions below on “How
to Brew Espresso” before removing the filter and brew
basket.
3. To clean the inside of the appliance, follow steps listed
on “How to Brew Espresso” using water only. Do not
immerse the appliance in water or attempt to reach
any of its internal parts.
BVMC-ECMP55_13ESM1.indd 11-12 2/22/13 2:26 PM