Olson Technology LP-DC-X - Manual (Page 3)

025-370447 REV X2 Page 3 of 10
SAFETY WARNINGS
LASER RADIATION
HIGH VOLTAGE
The Laser Plus power supply contains no user serviceable parts. There is exposed high voltage inside the
supply. The power supply housing should be opened only by factory service technicians.
FIRE HAZARD
The Laser Plus rear power supply fuse is a 3AG, 3.25A, slow blow fuse. To avoid a risk of fire, this fuse
should be replaced only with an identically rated fuse.
SHIPPING ALERT
The Laser Plus main chassis is not intended as a shipping container. Shipping the chassis with any module
installed can cause severe physical damage.
The laser transmitter should be disabled with the front panel switch whenever the optical connector is empty.
NEVER look into the end of a fiber optic cable, even at the LP-DC212 optical input.
Laser transmitters emit invisible radiation that can cause permanent eye
damage. AVOID DIRECT EXPOSURE TO BEAM. Operate only
with the proper optical fiber installed in the transmitter optical connector.