OnLine Power Constant Power 3 - Manual (Page 22)

OnLine Power
6002-034 REV. C 3-1
SECTION 3 - INSTALLATION
3-1 INSTALLATION
Install the unit using the procedures in this section. Final installation must be in accordance with NEMA standards
and conform to local electrical codes as appropriate.
3-4-1 Unpacking Constant Power 6
Unit is shipped on a pallet secured with metal bands and can be handled using a forklift or pallet jack.
DANGER!
CUT METAL BANDS CAREFULLY. THEY ARE UNDER TENSION AND MAY CAUSE
INJURY.
1. Position the container away from walls or other obstructions.
2. Cut metal shipping bands.
3. Remove cardboard cover. Avoid puncturing the cardboard cover with sharp objects which may damage the
surface of the unit.
4. Remove the unit from the pallet. Remember the Constant Power 6 can weigh as much as 300 pounds.
Check the weight of the unit on Table 2-1 before lifting.
5. Remove the plastic film.
6. inspect the unit for damage per Section 3-4-3 Inspection.
7. Move unit to installation site.
8. Before final positioning of the unit(s) verify all the routing of all input and output cabling.