Osburn AC02585 - Manual (Page 10)

10
Splitz-it 5-tON electric lOg Spliter Splitz-it 5-tON electric lOg Spliter
ORDERiNg REpAiR pARTS
Parts can be obtained from the store where your mini log
splitter was purchased.
Please include the following information with your order:
1. Part numbers
2. Part description
3. Quantity
4. Model number and serial number
SERVicE iNFORMATiON
In the event you experience trouble operating your log splitter,
follow the suggestions in the troubleshooting guide in this
section.
The guide will help you pinpoint the causes of common
problems and identify remedies.
We will always be glad to answer any questions you have,
or help you find suitable assistance. To order parts or inquire
about warranty, call or write us at the address found in the next
column, under the section ordering repair parts.
SERVicE, TROUbLESHOOTiNg AND REpAiR
TROUbLESHOOTiNg
SpLiTZ-iT 5-TON ELEcTRic LOg SpLiTTER bREAkDOwN
iMpORTANT
iN cASE OF A SERVicE pRObLEM, DO NOT SEND UNiT
bAck TO RETAiLER.
cONTAcT Sbi HEATiNg AccESSORiES,
AT 1 418 878-3040
pRObLEM pOSSibLE cAUSE REMEDY/AcTiON
Fails to split logs 1. Log is improperly positioned 1. Refer to Log Splitter Operation Section for log
loading
2. The size or hardness of the log exceeds
the capacity of the machine
2. Reduce the log size before splitting on the log
splitter
3. Wedge cutting edge is blunt 3. Refer to Sharpening Wedge Section to sharpen
the cutting edge
4. Oil leaks 4. Locate leak(s) and contact the dealer
5. Unauthorized adjustment was made onto
the maximum pressure limiting screw
5. Contact the dealer
The log pusher moves with
a jerking motion, makes an
unfamiliar noise or vibrates
excessively
1. Lack of hydraulic oil and excessive air in
the hydraulic system
1. Check oil level for possible oil refilling. Contact
the dealer.
Oil leak occurs around cylinder
ram or from other points
1. Air sealed in hydraulic system while
operating
1. Loosen bleed screw 3-4 rotations before
operating the log splitter
2. Bleed screw is not tightened before
moving the log splitter
2. Tighten the bleed screw before moving the
log splitter
3. Oil drain bolt with dipstick is not tight 3. Tighten the oil drain bolt with dipstick
4. Hydraulic control valve assembly and/
or seal(s) worn
4. Contact the retailer
contact service provider if above remedies fail.
SBIOMWENGSplitzIt.indd 10 1/10/2012 8:14:45 AM