OWON AG1022 - Manual (Page 25)

5.Front Panel Operation
(3)
Turn the knob or press / direction key to choose the desired waveform. E.g.
select ExpRise. Press F1 to output the Exponential Rise waveform.
The User-Definable Waveform
Press button and press F5 to select "Editable Wform".
Menu item Instruction
Create Wform Create a new waveform.
Select Wform
Select the waveform stored in internal storage (FLASH) or U disk
(USBDEVICE).
Edit Wform Edit the stored waveform.
How to Create a New Waveform
(1)
Enter the operation menu: Press →Editable Wform →Create Wform.
(2)
Set the number of waveform points: Press F1 to select "Wform Points", turn the
knob or press the number keys to input the desired value and choose the unit. X1, XK,
XM respectively represent 1, 1000, 1000,000. The waveform points range is 2～
1000,000.
(3)
Set the interpolation: Press F2 to switch between On/Off. If you choose On, the
points will be connected with beelines; otherwise, the voltages between two
consecutive points will not change, and the waveform looks like a step-up one.
(4)
Edit the waveform points: Press F3 to enter the operation menu.
 Press F1 to choose "Points", input the number of the point to be edited.
 Press F2 to choose "Voltage", input the voltage for the current point.

Repeat the step above, set all the points to your needs.
 Press F4 to choose "Store", enter the file system. If a U disk is connected,
press
/ direction key to select the storage. "USBDEVICE" is the U Disk
storage, "FLASH" is the internal storage. Choose Next level, enter the desired
20