Paso Sound PCDRW900SL - Manual (Page 28)

IMPORTANT SAFETY PRECAUTIONS

TASCAM CD-RW900SL

TASCAM CD-RW900SL
Unfinalizing CD-RW discs
If a CD-RW disc has been finalized, it is possible to erase
the Table of Contents in the following way:
1. With the finalized disc loaded and the unit in stop
mode, press the ERASE/DEL key on the front panel
or the ERASE key on the remote control.
Rotate the MULTI JOG dial or press the SKIP key
on the remote control to select UNFINALIZE? .
Push the MULTI JOG dial or press the ENTER key
to confirm.
If you do not want to proceed with the unfinaliz-
ing process, press the
ERASE/DEL key on the front
panel or the SKIP key on the remote control.
2. The display shows
Sure?
If you do not want to proceed with the unfinalizing
process, press the
STOP key.
3. To start the unfinalizing process, press the MULTI
JOG dial or the ENTER key again.
When unfinalization has been chosen, the display
shows
Erase flashing and the remaining time.
The unit starts counting down from a time shown
on the display.
4. When finalization has been finished successfully,
Complete
appears on the display, and the TOC indi-
cator will go off.
Finalizing
As has been explained earlier (“About Finalizing” on page
7), in order for a disc to become a standard CD, it must
have a Table of Contents (TOC) written to it. This process
is known as finalizing.
An unfinalized disc can always be distinguished on the
CD-RW900SL by the
TOC indicator under the disc type on
the display being unlit when the disc is inserted.
To finalize a disc:
1. Load the unfinalized disc, and with the unit in stop
mode, press the FINALIZE key.
The display shows FINALIZE?
If you do not want to proceed with the finalizing
process, press the
FINALIZE/INS key on the front
panel or the FINALIZE key on the remote control.
2. To start the finalizing process, push the MULTI JOG
dial or press the ENTER key on the remote control.
The display shows Sure?
If you do not want to proceed with the finalizing
process, press the
STOP key.
3. When finalization has been chosen, the display
shows the TOC flashing and the remaining time.
The unit starts counting down from a time shown
on the display.
4. When finalization has been finished successfully,
Complete appears and the TOC will be lit on
the display.
NOTE
During the finalizing process, all key presses are ignored.
This section deals with the actions taken after record-ing:
finalizing for CD-R and CD-RW discs, and erase opera-
tions for CD-RW discs.
Once finalized, CD-R discs are truly final—no more can
be recorded on them. By contrast, CD-RW discs can be
“unfinalized” using the CD-RW900SL, i.e. their TOC can
be deleted, and if there is space, further material can be
recorded on them. Even if the disc is full, tracks can be
erased following the unfinalize process, and new material
can be recorded.
6 − After recording