Paso Sound P202MKV - Manual (Page 19)

IMPORTANT SAFETY INSTRUCTIONS
TASCAM 202 MK V
19
4 − Recording
To record a mix of voice and another audio source,
you need to adjust the mic input level and then fine
tune the overall recording level.
1. Plug your microphone into the MIC jack on the
front panel.
2. Start playing the audio source, switch the deck
into the record-pause mode (by pressing the
RECORD (º) key), and temporarily adjust the
INPUT control to a relatively low level.
3. Speak into the mic and adjust the MIC level
control to get the optimum balance between
your voice and the other source.
4. Fine tune the overall recording level using the
INPUT control so that the level meter reads 0
dB at peaks.
5. When everything is ready, start recording as
instructed earlier in this manual.
Audio source
Adjustment of
mic input level
Adjustment of overall
recording level
Adjusting mix recording level
This function allows you to make uninterrupted
recordings on both sides of two tapes.
1. Load cassette tapes for recording into the
TAPE 1 and TAPE 2 compartments.
Side “A” facing you
2. Set the REV MODE switch to the ä ( CONT
REC/PLAY ) position.
Set the DOLBY NR switch to the ON position if
you want to.
3. Press the TAPE 1 deck’s RECORD (º) key.
The deck enters the record-pause mode. π and
will light on the display. Now adjust the
recording level and any other settings, as re-
quired.
Continuous recording