Timer playback, Playback, Important safety instructions – Paso Sound P202MKV User Manual

Page 23: 4 − recording

Advertising
background image

IMPORTANT SAFETY INSTRUCTIONS

TASCAM 202

MK

V

23

4 − Recording

NOTE

Be careful not to press the PLAY

(˙ or ¥) key

whose arrow points in the same direction as the
indicator. Doing so will start playback.
You do not need to adjust the recording level or

set the Dolby NR system, as both depend on the
pre-recorded source tape.

4

Press the

SYNC REVERSE

key.

The

SYNC REV

indicator will light on the display.

The

SYNC REVERSE

key does not work if the

reverse mode is set to any positions other than

Ë

or if the transport direction of both decks is set to
reverse (

˙

).

5

Press either

DUB START

key to start dubbing.

For normal speed dubbing, press the

NORMAL

key. For high-speed dubbing, press the

HIGH

key.

High-speed dubbing makes a copy at approximate-
ly two times the normal speed. We recommend
normal speed dubbing for best audio quality.

During dubbing, either the

NORM DUB

or

HIGH DUB

indicator lights steadily on the display.

During normal speed dubbing, only the following
keys work:

TAPE 1 deck:

STOP

(H)

TAPE 2 deck:

PAUSE

,

REC MUTE

,

STOP

(H)

During high-speed dubbing, only the

STOP

(

ª

)

key works.

Pressing the

STOP

(

ª

) key on either deck stops

both tapes at once.

Neither

DUB START

key works immediately after

the tape is fast-forwarded or rewound to the end.
Wait for 5 seconds or more before pressing the
key.

NOTE

During dubbing, the pitch control does not

work.
Recording level adjustment is not necessary for

dubbing, as the recording level is set to the level
of the pre-recorded tape. Operating the INPUT
control, before or after starting dubbing, has no
effect at all.
If a nearby television set is switched on during

high-speed dubbing, a high-pitched interfer-
ence noise may be recorded on the tape. To
avoid this, either perform dubbing at normal
speed, or turn off the television.

Timer playback

1. Connect this unit and stereo system to a com-

mercially available audio timer.

2. Set the power switch of all components to ON.

3. Load a prerecorded cassette tape in TAPE 1 or

2.

You can also insert tapes into both decks. In this
case, TAPE 1 starts first.

Playback

Advertising