PSE Archery Viper Series Crossbow - Manual (Page 5)

1) Mount prod to stock assembly. Clip the cable slide (I)
on top of the cables with one cable in each slot. Place
slide in the center of the prod (Fig. 3a). Slide cables
and slide into cable slot of stock assembly with the
string riding on top of the rail (figure 3b). Insert the
prod into stock assembly as shown in figure 4 and
secure with the prod attachment screw (G), flat
washer (F) and lock washer (E) as shown in figure 5.
Tighten screw with the Allen key provided.
2) Install Stirrup. Insert stirrup in the prod (figure 6) so
that the flats in the stirrup line up with the set screws.
Tighten the set screws in the bottom of the prod with
an hex key to secure the stirrup (figure 7).
Fig 6 Fig 7
Fig 4
Fig 5
Fig. 3a
Fig. 3b
-5-