Radionic ZXE–5000-UNVSeries - Manual (Page 3)

KIT CONTENTS & INSTALLATION INSTRUCTIONS for Part Number: ZXE-5000-E-UNV
EXTERNAL POWER SUPPLY with
BOX TYPE
Exit Sign
• One (1) LED Strip
• One (1) Power Supply/Driver One
• Two (2) Mounting Brackets for LED Strip
• Two each: Screws, Washers, Nuts
• Three (3) Wire Connectors
• 2 push-in connectors
I NSTALLATION I NFORMATION :
1. Select a suitable mounting location in the exit sign fixture. For most exit signs, the fixture should be installed as shown in Figure A2
(external power supply for box type of signs). The LEDs should be pointed towards the word “EXIT.” If you notice that the words on the
sign are not lit up to full brightness and visible from at least 100 ft, remove the LED fixture and start over. Never mount the LED strip
on the right/left side of the fixture. Be sure not to block any vents. The power supply may be mounted on the right/left side. (see
options A and B in figure A2)
FIGURE A2:
If retrofitting Sign Box type of exit sign, use the diagram below that corresponds to your exit sign’s brand/model:
LED Strip Mounting bracket
installation
2. To install the LED Strip, use the two mounting brackets, washers, nuts and two screws (provided). Pre-drill holes for mounting
brackets and corresponding hardware in a suitable location. The LED strip must be centered in the mounting area of fixture. Place
screw through center hole of bracket. Using a Philips screwdriver , install the mounting brackets to the suitable mounting location on
the fixture (as described in step #1 and figure A2, above) using the screws, washers and nuts (provided). Screw in the mounting
brackets first to the mounting location on the fixture (as described in step #1 above), then snap in fixture.
3. Use push-in connectors (provided) to connect PSU BLUE lead to LED Strip BLUE lead, then, connect PSU RED lead to LED Strip RED
lead.
4. Mount the power supply on the SIDE or TOP using screws
5. To remove LED fixture after installation, use a small screwdriver to slightly pry one side of the metal mounting brackets open and
then twist the fixture away from that side of the bracket.
6 . WIRING THE FIXTURE
• Turn the main breaker/fuse to the fixture off
Refer to FIGURE A3 (below)
Bring the power input leads (black/white/green or hot/neutral/ground) to the input leads of the light fixture as shown.
Twist one lead of the stripped input lead to the Black (Hot) power input lead. Secure with wire connector (provided).
Twist second lead of the stripped Input lead to the White (Neutral) power input lead. Secure with wire connector (provided).
Twist green grounding wire attached to PSU to the Green (Ground) power input lead. Secure with wire connector
(provided).
After proper connections are made, in accordance with the National Electrical Code and local codes, turn on the main power
FIGURE A3:
PAGE E-1