Radionic ZXE–5000-UNVSeries - Manual (Page 4)

KIT CONTENTS & INSTALLATION INSTRUCTIONS for Part Number: ZXE-5000-E-UNV
for EXTERNAL POWER SUPPLY for use with EDGELIT type of sign
• One (1) LED Strip
• One (1) Power Supply/Driver One
• Two (2) Mounting Brackets for LED Strip
• Two each: Screws, Washers, Nuts
• Three (3) Wire Connector
• 2 push-in connectors
I NSTALLATION I NFORMATION :
1. Select a suitable mounting location in the exit sign fixture. See FIGURE A1 (below) The LEDs should be pointed down
towards the word “EXIT.” If you notice that the words on the sign are not lit up to full brightness and visible from at least
100 ft, remove the LED fixture and start over. Be sure not to block any vents.
FIGURE A1 If retrofitting an Edge-lit type of exit sign, use the diagram below that corresponds to your exit sign brand/model:
(Note: LED strip to be mounted in CENTER of mounting area) ‘
2. To install the LED Strip, use the two mounting brackets, washers, nuts and two screws (provided). Pre-drill holes for mounting
brackets and corresponding hardware in a suitable location. The LED strip must be centered in the mounting area of fixture. Place
screw through center hole of bracket. Using a Philips screwdriver and install the mounting brackets to the suitable mounting location
on the fixture (as described in step #1 and figure A1) using the screws, washers and nuts (provided). Screw in the mounting brackets
first to the suitable mounting location on the fixture (as described in step #1 above), then snap in fixture. (See diagram below, left). *
For Lithonia LRP Series: follow above instructions, but mount to the Formex provided instead of metal hardware. Slide in the plastic
after mounting is complete.
3. Use push-in connectors (provided) to connect PSU BLUE lead to LED Strip BLUE lead, then, connect PSU RED lead to LED Strip RED
lead.
4. Mount power supply in suitable place inside EDGELIT exit sign fixture. Do not obstruct view of LEDs.
5. To remove LED fixture and power supply after installation, use a small screwdriver to slightly pry one side of the metal mounting
brackets open and then twist the fixture away from that side of the bracket.
6. WIRING THE FIXTURE
Turn the main breaker/fuse to the fixture off
Refer to FIGURE A4 (below)
Bring the power input leads (black/white/green or hot/neutral/ground) to the input leads of the light fixture as shown.
Twist one lead of the stripped Input lead to the Black (Hot) power input lead. Secure with wire connector (provided).
Twist second lead of the stripped Input lead to the White (Neutral) power input lead. Secure with wire connector (provided).
Twist green grounding wire attached to LED fixture to the Green (Ground) power input lead. Secure with wire connector
(provided).
After proper connections are made, in accordance with the National Electrical Code and local codes, turn on the main
power.
FIGURE A4:
PAGE E-2