Dimplex DFG2562SS - Manual (Page 14)

14 www.dimplex.com
Maintenance
Replacing Light Bulbs:
①
Carefully remove the front
glass assembly. be aware that
some of the glass media may fall
out of the tray (Figure 8).
⑤
remove flicker rod from motor
(see Figure 8).
⑥
unscrew bulb(s) counter
clockwise.
⑦
Insert new bulb(s).
⑧
Push flicker rod back onto
motor shaft and replace opposite
end of flicker rod back into
support bracket.
⑨
replace media tray back into
firebox.
⑩
Gently pour and evenly
spread the glass media.
⑪
replace glass assembly.
glass Cleaning
The front glass is cleaned in
the factory during the assembly
operation. During shipment,
installation, handling, etc., the
front glass may collect dust
particles, these can be removed
by dusting lightly with a clean dry
cloth.
To remove fingerprints or other
marks, the glass can be cleaned
with a damp cloth. The glass
should be completely dried with
a lint free cloth to prevent water
Figure 8
Flicker rod
Glass media
and tray
Front Glass
Assembly
②
Empty the tray of glass media.
CAUTION: handle glass
media with care as some
pieces may have sharp edges.
③
Lift the tray up and remove
from firebox.
④
Pull flicker rod towards the
motor and bend gently to remove
the opposite end from the support
bracket.